Chat with us, powered by LiveChat

Welcome, Guest!
to your account.
NAPA Auto Parts GRANDVIEW
844 Grandview Ave
Columbus,  OH  43215-1124
(614) 488-3176
Reserve Online Participant
Store Hours
CLOSED
Mon-Fri:7:00 AM-6:00 PM
Sat:8:00 AM-4:00 PM
Sun:Closed
This store has been geolocated for you.
Looking to get a repair done? Find an Auto Care Center

 

text.skipToNavigation
12/24 Volt 120A Flashing Power Supply and 120/60/40/10A HD Battery Charger

12/24 Volt 120A Flashing Power Supply and 120/60/40/10A HD Battery Charger

Part #: SOR PL6850
Line: Clore Automotive
Why?

This item is currently not at your store, but is available for order. Please call store to verify the specific location and delivery details for this item. Note that additional shipping charges may be required.

Requested quantity is not available. Please update the quantity below.
EMAIL TO YOUR FRIEND

Features & Benefits

Warranty

The PL6850 is designed to provide stable power, on demand up to 120 amps, to a vehicle electrical system to support module reprogramming. It is also designed specifically for fleet service battery charging with a maximum charge rate of 120 amps, to quickly and effectively bring 4- and 8-battery Group 31 packs back to full charge.

In power supply mode, the PRO-LOGIX PL6850 provides power to maintain vehicle electrical system voltage at a preset level, increasing its output in response to system load increases to maintain a stable power environment for successfully reprogramming. It features a voltage output range of 13.1-14.9V, adjustable in 0.1V increments. allowing the operator to dial the output in exactly as specified by the supplier of the vehicle under service. It features fast load responsiveness for ultra-quick recovery from system demand increases. It also delivers its massive power with minimal voltage ripple (<100mV), providing a clean flow of power to the vehicle without risk of programming interference.

In charging mode, the PL6850 utilizes advanced microprocessor-controlled logic to precisely deliver a fully automatic charging routine designed to optimally charge and maintain each battery or battery pack serviced. The PL6850 features the ability to properly charge a wide variety of lead acid battery types, including Conventional, AGM, Spiral Wound, Start-Stop, Deep Cycle and Marine batteries – plus LiFePO4 lithium batteries – for virtually any lead acid battery type installed in a vehicle, the PL6850 can deliver a proper, beneficial charge. The PL6850 adapts its charging approach based on the needs of each battery or battery pack it services. Such adaptations can include activating a soft start mode on deeply discharged batteries, a battery repair mode on older/distressed batteries and temperature compensation when charging in extreme temperatures. It also incorporates numerous features to make charging safer for the operator and the vehicle/battery being charged.


  • •Power Supply Mode:
    - 0-120A (12V, on demand) power supply mode to maintain system voltage
    - 0-60A (24V, on demand) power supply mode to maintain system voltage
    - Power supply mode provides optimal support for vehicle reprogramming and ADAS recalibration
    - Power supply mode has minimal voltage ripple (<100mV)
    - Power supply mode features Rapid Load Response (RLR) technology
  • •Charge Mode:
    - 120/60/40/10A (12V) charge modes allow quick, efficient charging of all battery sizes
    - 60/40/10A (24V) charge modes allow quick, efficient charging of HD battery packs
  • Properly charges Flooded, AGM, Spiral Wound, Deep Cycle and Marine lead acid batteries, plus LiFePO4 lithium batteries
  • Forced start mode allows charging of totally dead batteries
  • Battery repair mode overcomes battery sulfation to restore reserve capacity
  • Reverse polarity protection and battery fault detection
  • Extra-long 13' cable reach
  • PowerJaw clamps provide improved access to hard-to-reach batteries
  • PowerJaw clamps allow the hood to be closed (most vehicles) during ADAS calibration
  • Requires 20A service

Specifications

Rated For Outdoor Use No
Overload and Short Circuit Protection Yes
Onboard Mounting No
Start Mode Auto
Battery Charger Type Automatic
Rolling No
VMRS Code 153007000
Thermal Overload Protection Yes
Battery Type Absorbed Glass Mat (AGM)
Quick Connect Harness Included No
Cooling Fan Yes
In Built Fuse Included Yes
Display Type LED
Automatic Shut Off Yes
Carry Handle Yes
Grade Type Heavy Duty

Safety Information

Vehicle Fitment Guide

Product Reviews